Ricoh B064 Service Manual page 809

JOGGER FENCE ADJUSTMENT
Paper
14. To check for skew, measure from the edges of the innermost sheet and make
sure that the amount of skew is less than 2 mm for
, , ,
If or
(1) Insert a screwdriver into the door switch then push in the stapler unit.
(2) Scan and print 3 booklet sheets in book mode from the platen (do not scan
the originals with the ADF).
(3) Once the paper is fed into the stapler unit and the machine stops, pull the
stapler unit out.
(4) Press the  key on the operation panel, then remove the screwdriver from
the door switch as soon as the jogger fences come close to the paper
edges (about 10 mm wider than the paper width).
(5) Measure the gaps between the edges and fences on both sides.
Paper/Fence gap (top + bottom) = 0 to 0.5 mm
(6) If the gaps are too wide or too narrow, do SP6120 (Staple Jogger
Adjustment) to adjust the gap for the paper size.
15. Repeat Step 14. If
B468/B469/B674
is more than 2 mm, do the following procedure.
, , ,
or is still more than 2 mm, go to Step 16.
20
Paper
B468R913.WMF
, , ,
.
13.W M F
SM