Service Program Mode; Service Program Mode Operation; Entering And Exiting Sp Mode - Ricoh B064 Service Manual

Rev. 05/2005
5. SERVICE TABLES

5.1 SERVICE PROGRAM MODE

5.1.1 SERVICE PROGRAM MODE OPERATION

The service program (SP) mode is used to check electrical data, change modes,
and adjust values.
• SP Mode (Service). Includes all the options in the SP displays for normal
maintenance and adjustments.
• SSP Mode (Special Service). Includes the normal SP modes and some
additional options in the SP displays not required for normal settings and
adjustments. (These SP numbers are in bold type and most are marked "DFU"
(Design or Factory Use) in the tables.) Do not change these settings needlessly.

CAUTION
Never turn off the main power switch when the power LED is lit or flashing.
To avoid damaging the hard disk or memory, press the operation power
switch to switch the power off, wait for the power LED to go off, and then
switch the main power switch off.
Entering and Exiting SP mode (B140 Series/B064 Series)

1. Press the Clear Mode key.
 2. Use the keypad to enter "107".

3.
4. Enter the Service Mode.
Copy SP
 Copy SP
Exit 5. Press Exit to return to the copy window.
Entering and Exiting SP mode (G126)
[] []


SM
Hold down Clear/Stop for at least 3 seconds.
The Copy SP or PM Counter items are displayed. The Printer
SP and Scanner SP are also available if installed.
To enter the Normal Service Mode:
On the touch-panel, press Copy SP.
To enter the Special Service Mode:
Hold down  and then press Copy SP.
Press the "Up/Down" keys together for approximately 5
seconds, then press the "Enter" key.
To exit SP Mode, select "End" from the main service menu,
then press the "Enter" key.
5-1
SERVICE PROGRAM MODE
B064 Series/B140 Series/G126