Draytek Vigor 3200 Series User Manual page 139

DHCP Server
Configuration
DNS Server IP Address
After finishing all the settings here, please click OK to save the configuration.
For NAT Usage - Click this item to invoke NAT usage.
For Routing Usage - Click this item to invoke Routing
usage.
IP Address - Type in private IP address for connecting to a
local private network (Default: 192.168.9.1).
Subnet Mask - Type in an address code that determines the
size of the network. (Default: 255.255.255.0/ 24)
DHCP stands for Dynamic Host Configuration Protocol.
The router by factory default acts a DHCP server for your
network so it automatically dispatch related IP settings to
any local user configured as a DHCP client. It is highly
recommended that you leave the router enabled as a DHCP
server if you do not have a DHCP server for your network.
If you want to use another DHCP server in the network
other than the Vigor Router's, you can let Relay Agent help
you to redirect the DHCP request to the specified location.
Enable Server - Let the router assign IP address to every
host in the LAN.
Disable Server – Let you manually assign IP address to
every host in the LAN.
Start IP Address - Enter a value of the IP address pool for
the DHCP server to start with when issuing IP addresses. If
the 1st IP address of your router is 192.168.9.10, the
starting IP address must be 192.168.9.11 or greater, but
smaller than 192.168.1.254.
IP Pool Counts - Enter the maximum number of PCs that
you want the DHCP server to assign IP addresses to. The
default is 50 and the maximum is 253.
Gateway IP Address - Enter a value of the gateway IP
address for the DHCP server. The value is usually as same
as the 1st IP address of the router, which means the router is
the default gateway.
Type in the primary IP address for the router if you want to
use Static IP mode. If necessary, type in secondary IP
address for necessity in the future.
129 Vigor3200 Series User's Guide