Xerox WorkCentre M20 Service Manual page 89

4
Remove 1 E-clip, 1bearing,
then the MEA unit - pickup.
Figure 11 MEA unit - pickup removal
14. Prepare to remove the guide - M scan assembly, Figure 12.
2
Disconnect 2 ground
1
harnesses.
Disconnect CN2.
Figure 12 Preparation
15. Remove the guide - M scan assembly, Figure 13.
Work Centre M20 Family
3
Remove 1 E-clip, then the
bearing.
2
Remove 1 E-clip, then the
MEC clutch small (feed).
1
Disconnect the inline con-
nector.
3
Disconnect ELA HOU -
cover open switch inline
connector.
2
Remove the guide - M
scan assembly.
Figure 13 Guide - M scan assembly removal
16. Prepare to remove the MEA unit guide pick up assembly, Figure 14.
2
Disconnect CN4 and CN6.
17. Remove the MEA unit guide pickup assembly, Figure 15.
March 2004
4-17
1
If necessary, remove 4
screws.
1
Open the MEA unit
cover exit assembly.
Figure 14 Preparation
Repairs and Adjustments
REP 5.1