Xerox WorkCentre M20 Service Manual page 86

WARNING
Do not remove the DADF while the DADF is lowered. In the lowered position the coun-
terbalance springs are compressed and can cause injury when released.
4. Remove the ELA HOU - DADF, Figure 2. Place the ELA HOU - DADF on a solid flat sur-
face.
Figure 2 ELA HOU - DADF removal
5. Open the MEA unit - cover open, Figure 3.
Repairs and Adjustments
REP 5.1
2
Tilt the ELA - HOU
DADF forward then
remove.
1
6. Remove the front cover, Figure 4.
Pull up the ELA HOU -
DADF.
7. Remove the rear cover, Figure 5.
March 2004
4-14
1
Open the MEA unit - cover
open.
Figure 3 MEA unit - cover open
1
Remove 1 screw.
2
Unclip the front cover, then
remove the front cover.
Figure 4 Front cover removal
Work Centre M20 Family