Xerox WorkCentre M20 Service Manual page 100

Figure 2 MEA unit guide CST PA assembly removal
5. Remove the solenoid pickup and gear - pickup, Figure 3.
Repairs and Adjustments
REP 8.6
1
Remove 2 screws, then
the MEA unit guide CST
PA assembly.
Do not damage the IPR GND input when removing the ELA HOU pickup plus assembly.
6. Remove the ELA HOU - pickup plus assembly, Figure 4.
March 2004
4-28
3
Carefully push a 2mm allen
key (or similar tool) into the
hole to release the bearing.
4
While the bearing is released,
rotate it 90 degrees to align the
clips with the cutouts in the
machine frame. Slide the bearing
forward to remove.
2
1
Remove the gear
Remove 2 screws, then
pickup.
the solenoid pickup.
Figure 3 Solenoid and gear pickup removal
CAUTION
Work Centre M20 Family