Xerox WorkCentre M20 Service Manual page 91

4
3
Remove 3 screws, disconnect 2 ground harnesses,
then remove the cover P - gear.
Disconnect the MEC - clutch
small (registration) inline con-
nector.
Figure 17 Cover - P gear removal
20. Remove the ELA HOU - DADF motor assembly, Figure 18.
Work Centre M20 Family
2
2
Remove 1 E-clip and
Remove 3 screws, then the ELA
the MEC - clutch
small (duplex). HOU - DADF motor assembly.
1
Disconnect the MEC -
clutch small (duplex)
inline connector.
21. Remove the ELA HOU - duplex motor assembly, Figure 19.
Replacement
1. Replacement is the reverse of the removal procedure. When reconnecting the inline con-
nectors, ensure they are connected correctly:
March 2004
4-19
Figure 18 ELA HOU - DADF motor assembly removal
2
Remove 3 screws, then the
ELA HOU - duplex motor
assembly.
Figure 19 ELA HOU - duplex motor assembly removal
1
Disconnect CN5.
1
Disconnect CN4.
Repairs and Adjustments
REP 5.1