Rep 8.5 Mea Unit - Feed Roller Assembly - Xerox WorkCentre M20 Service Manual

Figure 4 ELA HOU - MP assembly removal
Replacement
Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 8.4, REP 8.5

REP 8.5 MEA Unit - Feed Roller Assembly

3
Parts List on PL 8.15
Remove the ELA HOU -
Removal
MP assembly.
1
Switch off the electricity to the machine. Disconnect the power cord from the customer
Release the harness.
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
2
NOTE: If necessary, refer to GP 20 for the acronym list and cross reference lists of more com-
Unclip the ELA HOU - MP
monly recognised part names.
assembly by releasing the
two clips from under the 1. Remove the ELA HOU - MP assembly, REP 8.4.
machine.
2. Pull out the tray 1 cassette assembly approximately 100mm (4 inches).
3. Prepare to remove the MEA unit - feed roller assembly, Figure 1.
4. Remove the MEA unit - feed roller assembly, Figure 2.
March 2004
4-26
WARNING
WARNING
CAUTION
1
Remove 3 screws.
Figure 1 Preparation
Work Centre M20 Family