Parameters Description - D-Link xStack DES-6500 User Manual

Figure 6- 83. CPU Interface Filtering Rule Table – Packet Content
To remove a previously created rule, select it and click the
Figure 6- 84. CPU Interface Filtering Rule Configuration - Packet Content
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters
Profile ID
Mode
Access ID
Type
xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch User Manual
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 - 100.
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
Ethernet instructs the Switch to examine the layer 2 part of each packet
•
header.
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
button. To add a new Access Rule, click the Add button:
111