The Fax Does Not Work Properly - Minolta Di2010f User Manual

9.4 The Fax Does not Work Properly

9.4 The Fax Does not Work Properly
Transmission is Poor
Fax Status
Original cannot be
scanned.
The original is fed
crooked.
When the image
received by the
destination is unclear.
The image received by
the destination is blank.
Automatic transmission
is not possible.
When the transmission
stamp is faint.
(optional)
Di2010f/Di2510f/Di3010f/Di3510f
Apparent Cause
Is the document too thick?
Is the original too thin or too small?
Is the glass dirty?
Does the width of the original match
the setting guide?
Is the original set correctly?
Is the glass dirty?
Is the writing on the original faint?
Is there any problem with the
connection to the receiving fax?
Is the surface of the document to be
transmitted set face-down? (When
using the paper feed tray)
Is the phone number incorrect?
Is the number telephone-dedicated?
Is the reason on the destination side?
(Paper empty, automatic reception
disabled, power is OFF, etc.)
Is the memory remaining low?
Is the stamp (replaceable stamp)
close to the end of its operational
life?
Countermeasures
Place the original on the glass and
then transmit the document.
Place the original on the glass and
then transmit the document.
Wipe the glass with a soft cloth.
Match the width of the original to the
setting guide.
Set the original correctly.
Wipe the glass with a soft cloth.
Set the scan density.
Check by making a copy with the
product. If the image of the copy is
clear, transmit again.
Set the surface of the document to be
transmitted set face-upward, and
transmit again.
Check the phone number.
Check the phone number.
Check the destination.
After the document stored in memory
has been sent and the memory
remaining increased, send again.
Replace the stamp (replaceable
stamp).
9
9-7