When The Machine Is Not Operating Correctly - Minolta Di2010f User Manual

9
9.3

When the Machine Is Not Operating Correctly

Symptom
Nothing appears in the touch panel.
The indicator on the [Start] key
does not light up in green.
Even though the [Start] key is
pressed, no copies are made.
The machine cannot be set to Copy
mode.
The machine cannot be turned on.
* If the problem is not corrected even after the operations described are performed, turn off the
machine,unplug its power supply cord, and the contact your service representative.
9-6
9.3 When the Machine Is Not Operating Correctly
Possible Cause
If only the indicator on the
[Start] key is lit, the machine is
in Energy Saver mode or Sleep
mode.
The machine has not been
turned on.
The contrast control knob for
the touch panel has been set
either too light or too dark.
The scanner power cord or the
interface cable is disconnected.
An access code has not been
entered.
The copy/print job is queued
and waiting to be printed.
The machine is still warming up
after just being turned on.
The machine is malfunctioning.
The machine is in Interrupt
mode (the "Interrupt" indicator
is lit).
The power supply cord has
been unplugged from the
electrical outlet.
The breaker for the electrical
circuit has been tripped.
Di2010f/Di2510f/Di3010f/Di3510f
Remedy
Press any key in the operation
panel to cancel Energy Saver
mode.
Check that the machine's
power switch has been set to "I"
and that the sub power switch
has been pressed in.
While looking at the touch
panel, adjust the contrast
control knob.
Set the power switch for the
machine to "O", and then re-
connect the scanner power
cord and the interface cable.
Enter the access code
according to the procedure
described in "Making Copies
Using Accounts".
Touch [Job List] to check the
jobs that are queued. Wait until
printing begins.
The machine takes about 17
seconds to warm up after it is
turned on.
Wait until the machine has
finished warming up.
Follow any messages that
appear on the touch panel.
Press the [Interrupt] key to
cancel Interrupt mode.
Plug the power supply cord into
the electrical outlet.
Close the breaker for the
electrical circuit.