Table of Contents
Advertisement
9
Symptom
There are dark specks or spots
throughout the printed output.
There are streaks in the printed
output.
The image is not aligned properly on
the paper.
The printed page is curled.
9-4
9.2 When Incorrect Copies Are Printed
Possible Cause
The original glass is dirty.
Either the document pad is
dirty.
The original document is
printed on highly translucent
material, such as diazo
photosensitive paper or
overhead projector
transparencies.
A double-sided document is
being copied.
The document is not positioned
correctly.
The document is not positioned
correctly in the duplexing
document feeder.
The original glass is dirty (while
using the duplexing document
feeder).
The document guides are not
slid up against the edges of the
document.
Curled paper was loaded into
the paper drawer.
The paper that was used (as
with recycled paper) curls
easily.
Di2010f/Di2510f/Di3010f/Di3510f
Remedy
Wipe the glass with a dry soft
cloth.
Clean the document pad with a
soft cloth dampened with a mild
detergent.
Place a blank sheet of paper on
top of the document.
If a thin double-sided document
is being copied, the information
on the back side may be
reproduced in the copy. Touch
[Density], and then select a
lighter density for the
background.
Correctly position the
document against the
document scales.
If the duplexing document
feeder is installed, correctly
adjust the document guides for
the size of the document.
Lift open the duplexing
document feeder, and correctly
position the document against
the document scales.
Wipe the glass with a dry soft
cloth.
Slide the document guides
against the edges of the
document.
Flatten the paper before
loading it.
Remove the paper from the
paper drawer, turn it over, and
then load it again.
Replace the paper with paper
that is not damp.
Advertisement
Table of Contents
