Parts Which Must Not Be Touched - Minolta EP1080 Service Manual

1-4. PARTS WHICH MUST NOT BE TOUCHED

(1) Screws
Purpose of Application of Red Paint
Red paint is applied to the screws which cannot be readjusted, set, or reinstalled in the field.
The basic rule is not to remove or loosen the screws to which red paint is applied. In addition,
be advised that, if two or more screws are designated as those which must not be touched on
a single part, only one representative screw may be marked with red paint.
(2) Variable Resistors on Board
Do not turn the variable resistors on boards for which no adjusting instructions are given in
"ADJUSTMENT."
(3) Other Screws
Lower Pre-Image Transfer
Guide Plate (2 screws)
Lens Rail height
setting screws (4)
D-4