16-Channel - Lorex LNR300 Instruction Manual

6 LAN: Connect a CAT5 RJ45 Ethernet cable for local and remote connectivity.
7 RS485: Not supported.
8 Ground
9 Power Port: Connect the included power cable.
10 Power Switch: Turns the NVR on / off.

16-Channel

1
1 Camera In: Connect IP cameras 1~8. Integrated PoE (Power Over Ethernet) ports provide
power to cameras and video connection to NVR.
NOTE: To connect cameras 9~16, see "Connecting Cameras over the Local Network" on page 9.
2 Video Out: Outputs the live display to a secondary monitor using a BNC cable (not included).
NOTE: You cannot see the mouse or system menus via BNC. Use a BNC to RCA adapter (not
included) to connect the NVR to RCA inputs (i.e. for a TV connection).
3 Audio IN/Audio OUT: Connect a microphone (not included) and 1 audio output device (e.g.
speakers; not included).
4 RS-232: Service only; not supported.
5 Power Port: Connect the included power cable.
6 Power Switch: Turns the NVR on / off.
7 USB Port: Connect a USB mouse (included) or USB flash drive (not included) for data backup
or firmware updates.
8 VGA Port: Connect a VGA monitor to view the system interface.
9 HDMI Port: Connect an HDTV or monitor to view the system interface.
10 LAN: Connect a CAT5 RJ45 Ethernet cable for local and remote connectivity.
11 RS485/Alarm: Not supported.
2 3 4
8 9
7 10 11
5
6
3