Configuring Ddns Settings - Lorex LNR300 Instruction Manual

• Sender's Address: Enter the sender's email address.
NOTE: To enter '@' or other special characters using the on-screen keyboard, click
up special characters. Click characters to input and click the arrows to view other
characters.
Click to open special
character selector
• Receiver Email: Enter the email address that will receive alerts.
• Select Receivers: Use to enter additional email addresses that will receive alerts. Alerts may
be sent to up to 3 addresses.
• Enable Attached Picture: Check to include an image attachment from the camera that
triggered the alert.
• Interval: Select the interval the NVR will wait between sending out emails when events occur.
5 Click Apply to save your settings. Click Test to send a test email.
NOTE: Before the NVR will send out email alerts for motion detection, you must enable the
Send Email action for each camera. See "Configuring Motion Detection Alarm Settings"
on page 59.

Configuring DDNS Settings

Lorex DDNS is available as an optional connectivity option. Please see "Appendix C: DDNS
Setup (Advanced)" on page 160 for details.
The primary connectivity option uses the Lorex Stratus service to connect to your system
over the Internet without requiring port forwarding or DDNS registration. For details, see
"Connecting to Your NVR Over the Internet on PC or Mac" on page 83.
To configure DDNS settings:
1 Right-click and then click Menu.
Configuration
to bring
Click to view other
special characters
Select Default
Enter sender's address
Enter additional
receivers
Enter receiver's address
Enable picture attachment
Select Interval
71