Removing The Hard Drive - Lorex LNR300 Instruction Manual

Appendix B: Installing or Replacing the Hard Drive

Removing the Hard Drive

Make sure that the power cable has been disconnected before changing the
hard drive.
To remove the hard drive:
1 Remove the screws from the back (x2) and side panels.
2 Remove the screws from each side panel (x3) and the top of the rear panel (x2) of the cover.
Do not remove the other screws on the rear panel.
3 Disconnect the power and data cables from the hard drive.
4 Turn the NVR over and remove the 4 hard drive screws. Remove the hard drive from the
system. Make sure to hold the hard drive in place while removing the screws to avoid
damaging the NVR.
5 Turn the NVR back over and replace the cover. Replace the side panel and rear panel screws.
158
Side panel screws
Rear panel screws
Remove the screws to
remove the hard drive