Audio Operations; Channel Parameter Screen - Roland VR-50HD Owner's Manual

Audio Operations

Channel Parameter Screen

Pressing the [SETUP] button for a channel displays the channel parameter screen.
The information displayed on the screen differs for channels 1 to 4, channels 5/6 to
11/12, and MASTER (output).
Procedure
1.
Press the [SETUP] button for the channel whose settings
you want to make .
The channel parameter screen appears.
2.
Touch the screen to select a parameter .
3.
Turn the [VALUE] knob to change the setting value .
• When the setting is an on/off value, every touch of the
parameter switches the value on or off.
4.
Press the [EXIT] button or the illuminated [SETUP] button
to finish making the settings .
NOTE
The value of a parameter is updated by the last-performed
operation among those described below.
• Operations at the channel parameter screen
• Operations using knobs and faders on the top panel
• Remote operation by an external device
• Loading settings saved in the unit's memory (p. 39)
Channels 1–4
Parameter Explanation
You set this to ON when using a microphone that
+48 V
requires phantom power.
When listening to audio through headphones, you
Solo can hear just the channels for which this value is set
to ON.
Mute
This mutes the audio on the selected channel.
This adjusts the input gain. You can also use the
Gain
[GAIN] knobs on the top panel to adjust this.
HPF This switches the high-pass filter (75 Hz) on and off.
This adjusts the level sent to the MAIN bus. You can
Level
also use the channel faders on the top panel to adjust
this.
This adjusts the amount of delay for correcting audio
Delay
that is out of sync with the video (lip-sync).
AUX Send This adjusts the level sent to the AUX bus.
This adjusts the amount of delay for correcting audio
AUX Delay and video sent to the AUX bus that are out of sync
(lip-sync).
Reverb Send
This sets the amount of reverb applied.
Pan This adjusts the left-right balance of input.
Equalizer
ON/OFF This switches the equalizer on and off.
These set the gain for the corresponding frequency
High, Mid, Low
bands.
Edit This displays an advanced setting screen.
Gate
ON/OFF This switches the gate feature on and off.
This sets the sensitivity at which the gate starts to be
Threshold
applied.
Edit
This displays an advanced setting screen.
Compressor
ON/OFF
This switches the compressor on and off.
This sets the sensitivity at which the compressor starts
Threshold
to be applied.
Edit This displays an advanced setting screen.
29