Roland VR-50HD Owner's Manual page 30

Audio Operations
Channels 5/6–11/12
Parameter Explanation
Follow This switches the Audio Follow function on or off.
When listening to audio through headphones, you
Solo can hear just the channels for which this value is set
to ON.
Mute This mutes the audio on the selected channel.
This selects the channel's audio input source.
LINE:
Analog audio incoming via the LINE jacks on the rear
panel is input.
Input
VIDEO:
Audio embedded in video is input. VIDEO is enabled
when SDI or HDMI has been selected for Input Assign.
This adjusts the level sent to the MAIN bus. You can
Level also use the channel faders on the top panel to adjust
this.
This adjusts the amount of delay for correcting audio
Delay
that is out of sync with the video (lip-sync).
AUX Send This adjusts the level sent to the AUX bus.
This adjusts the amount of delay for correcting audio
AUX Delay
and video sent to the AUX bus that are out of sync.
Reverb Send
This sets the amount of reverb applied.
This sends the left-channel audio to the left and right
Mono
channels; the right-channel audio is no longer heard.
Equalizer
ON/OFF This switches the equalizer on and off.
These set the gain for the corresponding frequency
High, Mid, Low
bands.
Edit
This displays an advanced setting screen.
30
MAIN (Output)
Parameter Explanation
This adjusts the output level of the MAIN bus. You can
MAIN Level
also use the [MAIN] fader on the top panel to adjust
this.
AUX Level This adjusts the output level of the AUX bus.
This selects whether the signals of the PGM bus or
the signals of the AUX bus are output via the various
output connectors.
Output Bus
You select from among SDI PGM–HDMI AUX when
audio input from HDMI or SDI has been assigned to
channels 5/6–11/12.