Video Operations
Switching the Video
NOTE
If a fade is applied to the final output, the video is not output to a projector or other output device. For more information, refer to "Applying a Fade
to Final Video Output" (p. 25).
Switching by Touching the Screen
1.
Press the MONITOR [INPUT] button, making the button
light up .
Input from the source equipment (channels 1–4) is displayed on the
monitor.
Upon startup, the VR-50HD sets channel 1 as the default selected
channel and channel 1 is displayed with a red border.
2.
Press any of the TRANSITION [CUT]–[WIPE] buttons to
select a transition effect .
Pressing the [CUT] button performs an instantaneous switch with
no transition effect applied.
If you want to apply a transition effect, press the [MIX] button or the
[WIPE] button.
CUT
No transition effect is applied.
MIX
The two pictures are blended together as the video is switched.
WIPE
The video is switched using a wipe.
24
3.
Use the TRANSITION [TIME] knob to set the duration of
the transition effect (from 0 to 4 seconds) .
At a setting of 0.0, no transition effect is applied.
MEMO
Pressing the TRANSITION [SETUP] button displays the detailed
setup screen.
Here you can set the wipe pattern and border color.
4.
Touch the screen for the channel you want to output .
If you pressed the TRANSITION [MIX] or [WIPE] button in step 3,
then the transition effect is applied.
During the transition time while switching from one channel to
another channel, red borders are displayed around the screens for
both channels.