Input Formats/Output Formats; Formats Inputtable Via The Different Connectors; Setting The Output Format - Roland VR-50HD Owner's Manual

Input Formats/Output Formats

This describes the video signals and formats that can be input via the input connectors, and the procedures for setting the output format for the
video signal.
Formats Inputtable Via the Different
Connectors
You can input signals of different formats via INPUT 1–4 on the
VR-50HD.
Signals of the formats shown below can be input via the respective
INPUT 1–4 connectors. The input format is detected automatically.
* Composite and RGB/component signals can input only via
INPUT 1 and 2. SDI and HDMI signals can be input via INPUT 1–4.
480i (576i)
720p
1080p
HDMI (1–4)
1280 x 720/60 Hz
1280 x 1024/60 Hz
1920 x 1080/60 Hz
480i (576i)
SDI (1–4)
1080i
COMPOSITE (1, 2) 480i (576i)
480i (576i)
COMPONENT (1, 2) 720p
1080p
1024 x 768/60 Hz
RGB (1, 2) 1280 x 800/60 Hz
1400 x 1050/60 Hz
NOTE
Set the frame rate of the incoming signal to match the setting
for Frame Rate at the System screen (refer to the "Reference
Manual" (PDF)).
* To display the System screen, touch System <Setup> in the
menu screen (p. 13).
MEMO
The input format of SDI or HDMI audio is linear PCM, 24-bit/48-
kHz, 2-channel.
22

Setting the Output Format

1.
2.
480p (576p)
1080i
1024 x 768/60 Hz
1280 x 800/60 Hz
1400 x 1050/60 Hz
720p
1080p
480p (576p)
1080i
1280 x 720/60 Hz
3.
1280 x 1024/60 Hz
1920 x 1080/60 Hz
4.
5.
Here you set the format of the signal output from the video output
connectors (RGB/COMPONENT, HDMI, and SDI).
Display the menu screen (p . 13) .
Touch Video <Output> .
The Video Output screen appears.
NOTE
Settings of <Red>, <Green>, and <Blue> in the Color Correction
are not applied on SDI outputs.
Touch <Format> .
The Video Format Select screen appears.
Touch the output format you want to set .
NOTE
When <1024 x 768>–<1920 x 1080> is selected, no signal is
output from the SDI OUT connectors.
Press the [MENU] button to exit the menu screen .