Network Configuration - Avaya S8710 Installing And Configuring

Network configuration

NOTE:
Write down the original settings in case you need to change them back.
A new network connection must be configured as follows:
NOTE:
These instructions are for Windows 2000/XP only.
1
On your computer desktop, right-click My Network Places and left-click Properties to display
the Network Connections window.
Windows 2000/XP should have automatically detected the Ethernet card in your system and
created a LAN connection for you. More than one connection may appear.
2
Right-click on the correct Local Area Connection and left-click Properties to display the Local
Area Connection Properties dialog box.
3
Select Internet Protocol (TCP/IP).
4
Click Properties to display the Internet Protocol (TCP/IP) Properties dialog box.
5
On the General tab, select Use the following IP address. Enter the following:
•
IP address:
•
Subnet mask:
Make a note of any IP addresses or other entries that you have to clear. You may need to restore
them later to connect to another network.
6
Select Use the following DNS server addresses. The entries for Preferred DNS server and
Alternate DNS server should both be blank.
7
Click Advanced at the bottom of the dialog box to display the Advanced TCP/IP Settings dialog
box.
8
Click the DNS tab. Make sure no DNS server is administered (the address field should be blank).
9
Click OK, OK, and Close to close all the windows.
Installing and Configuring the Avaya S8700 or S8710 Media Server
June 2004
192.11.13.5
255.255.255.252
Accessing the media server
Network configuration
87
A