Avaya S8710 Installing And Configuring page 53

6
Type
ipsilogin
NOTE:
The craft login used on the IPSI has a different password than the craft login used on the
media servers.
7
Log in as craft.
Prompt = [IPADMIN]:
Type show control interface and press Enter.
settings.
9
Type
set control interface ipaddr netmask
provided IP address and
10
Press Enter to effect the changes.
11
Type show control interface
The IP address, subnet mask, and default gateway information will be displayed.
Verify that the proper information was entered.
12
If required, type
provided IP address for their gateway.
13
Press Enter to effect the changes.
14
If required, use the
set port duplex
and diffserv parameters for the IPSI. Use Help to obtain syntax guidelines for these commands.
15
Type
reset
Answer Y to the warning.
NOTE:
Resetting the IPSI terminates the administration session. If further administration is
required, start a new telnet session to the IPSI.
Installing and Configuring the Avaya S8700 or S8710 Media Server
June 2004
and press Enter (abbreviated command = il).
netmask is the customer provided subnet mask.
and press Enter.
set control gateway gateway
,
set vlan priority set vlan tag
(1 full),
set port speed
and press Enter
Programming the IPSI circuit packs
8
Type and press Enter to see the current
show port 1
and press Enter, where
and press Enter, where
, ,
set vlan id set port negotiation
(1 100 MB), and
set diffserv
Connecting to the IPSIs
is the customer-
ipaddr
is the customer-
gateway
(1=disable),
commands to enter VLAN
53
4