Powering Up The Media Server; Accessing The Media Server; Setting Up Telnet - Avaya S8710 Installing And Configuring

Configuring the media server

Powering up the media server

1
S8700: Connect the AC power cord to media server 1 and to UPS 1 to power it up.
S8710: Connect the AC power cord to media server 1 and to UPS 1. Press the Power button on the
front to power it up.

Accessing the media server

1
Connect the laptop to the services port (port 2 [Eth1]) on the back of the media server using a
crossconnect cable.
2
Place the CD with Avaya Communication Manager in the CD-ROM drive on the media server.
3
Wait at least 3 minutes after powering up before starting a Telnet session to access the information
on the CD.

Setting up Telnet

The Microsoft Telnet application may be set to send a carriage return (CR) and line feed (LF) each time
you press Enter. The installation program sees this as 2 key presses. If running Windows 2000/XP, you
need to correct this before you copy the Remaster Program to the hard drive.
1
Click Start > Run to open the Run dialog box.
2
Type telnet
3
Type
display
Sending only CR
then close the dialog box.
If message says
Sending both CR & LF
then continue with step 4.
4
Type
unset crlf
5
Type display
Sending only CR
6
Close the dialog box.
34
NOTE:
You must place the CD in the drive immediately.
NOTE:
Use a telnet session to access the information on the CD.
and press Enter to open a Microsoft Telnet session.
and press Enter to see the current settings. If message says
and press Enter.
and press Enter to verify that the settings changed. The message says
Installing and Configuring the Avaya S8700 or S8710 Media Server
June 2004