Programming The Ipsi Circuit Packs; Using Dhcp Addressing - Avaya S8710 Installing And Configuring

4 Connecting to the IPSIs

Programming the IPSI circuit packs

Programming the IPSI circuit packs
IP server interface (IPSI) circuit packs get IP addresses in one of two ways:
•
Using dynamic host configuration protocol (DHCP), if a dedicated (private) control network
•
Using static IP addressing, if a nondedicated (public) control network.

Using DHCP addressing

For the TN2312BP IPSI circuit packs to get IP addresses dynamically, you must first assign the switch ID
(A through J) and the cabinet number (01 through 64) to each IPSI circuit pack. For G650 Media
Gateways, a cabinet is defined as one or more media gateways connected by TDM cable, which is called
a G650-rack-mount-stack.
Administering the location assignment
1
Fully insert the TN2312BP IPSI circuit pack. If necessary, reseat the circuit pack to begin the
programming sequence.
2
Insert a pen, golf tee, or similar object (no graphite pencil) into the recessed push button switch.
50
NOTE:
Before beginning, read this procedure to familiarize yourself with it. With DHCP
addressing, there are certain sequences that need to be completed before a predetermined
time-out interval.
NOTE:
You must do the following steps within 5 seconds after inserting the circuit pack.
CLK
NOTE:
If you pass up the letter or number that you want, you must either cycle through all the
letters or numbers to get to the one you want or reinsert (reseat) the circuit pack and begin
again.
Installing and Configuring the Avaya S8700 or S8710 Media Server
S
E
R
V
June 2004