Avaya S8710 Installing And Configuring page 52

4 Connecting to the IPSIs
Programming the IPSI circuit packs
Figure 1: Connecting directly to the IPSI
cadlipsi KLC 031502
Figure notes
1 Services laptop
2 PCMCIA Network Interface Card (NIC)
1
Connect the services laptop computer to the top port on the IPSI circuit pack faceplate.
2
From the services laptop Start Menu, click Start > Run to open the Run dialog box.
3
Type
4
Type
responds with one of the following:
•
•
5
Type
Prompt = [IPSI]:
52
1
NOTE:
Make sure you have the password before proceeding.
command and press Enter to open a MS-DOS Command Line window.
arp -d 192.11.13.6 and press
The command line prompt when the cache has been cleared.
The phrase: The specified entry was not found. This is returned when the specified IP
address does not currently contain an entry in the ARP cache.
and press Enter to open the Telnet window and connect to the IPSI
telnet 192.11.13.6
NOTE:
While connected to the IPSI, type
two or three letter abbreviations.
Installing and Configuring the Avaya S8700 or S8710 Media Server
2
3
3 NIC adapter cable (if necessary)
4 CAT5 crossover cable to IPSI
Enter to clear the ARP cache in the laptop. This command
or to obtain online help. Most commands have
help ?
CLK
S
E
R
V
I
C
E
N
E
T
W
O
R
K
4
June 2004