Reducing Horizontal Bands (Feed Correction Function) - Roland VersaUV LEC2-300 User Manual

Using the Correction Functions

Reducing Horizontal Bands (Feed Correction Function)

Perform corrections to make the band-shaped "stripes" on the printed surface less noticeable.
The band-shaped "stripes" are called "horizontal bands" or "banding." Horizontal bands are caused by the subtle
changes in the movement distance that occur when feeding the media depending on the media's thickness. We
recommend making corrections to match the media you are using.
First, print a test pattern, and then determine and enter the correction value. After entering the correction value,
print a test pattern again and check the correction results. Repeat the process of printing a test pattern and enter-
ing a correction value several times to find the optimal correction value.
Procedure
1.
If using roll media, check that the media is not sagging.
2.
Press [MENU].
3.
Press [▼] several times to display the screen shown below.
MENU
CALIBRATION
4.
Press [▶] to display the screen shown below.
CALIBRATION
TEST PRINT
5.
Press [ENTER].
Printing of the test pattern starts.
6.
When printing of the test pattern is finished, press [▼], then [▶] to display the screen shown below.
SETTING
0.00%
7.
View the printed test pattern, and then determine the correction value.
The current correction value (
( ) and overlap (
select "-0.40." When you cannot choose between two sequential numbers, specify a value that is between
them.
8.
Press [▲] or [▼] to select the correction value.
SETTING
0.00%
9.
Press [ENTER] to confirm your entry.
10.
Press [◀] or [▼] to display the screen shown below.
124
1. Optimizing the Output Quality
0.00%
) is that of the figure indicated by "
) between the upper/lower squares smallest (
-0.40%
." Select the value to make the gap
). In the case of the following figure,