Expanding The Printing Area By Reducing The Margins - Roland VersaUV LEJ-640 User Manual

Description
When using transparent media or opaque, high-gloss media, the width and loading position cannot be read
automatically. Therefore they must be set manually. If they are set incorrectly, ink may be applied where there
is no media.
SHEET POS.
CANCEL
ends automatically after a certain interval, even if you're still making settings there.
The settings for the media width and start position made here are effective only when [SHEET TYPE] is set to
"CLEAR." Selecting "OPAQUE" disables the settings, although the setting values are saved in memory. Choosing
"CLEAR" again enables the values set previously.
When using transparent media or opaque, high-gloss media, the machine cannot detect the edge of the
media, causing the machine to continue printing even if the media runs out. Therefore when using these
types of media, make sure to confirm the size of the print data and the amount of media remaining. To cancel
printing, press .
Default Setting
[SHEET TYPE]: OPAQUE
[SHEET WIDTH]: 1625mm (64 inches)

Expanding the Printing Area by Reducing the Margins

Procedure

Press .

MENU
SUB MENU

SUB MENU
SIDE MARGIN

SIDE MARGIN
10mm 5mm
A type of media is
displayed.
Accommodating to the Types and Condition of Media
To quit making settings at the [SHEET POS.] menu item, use
"CANCEL," then close the front cover 1 and press
Note that to keep the print heads from drying out, the [SHEET POS.] menu item
Press
the left appears.
Press
Press
the left appears.
Press
Press
Press
When "SHEET SETUP" is set to any value other than "RIGID," the screen
shown on the left appears and setting is complete.
When "SHEET SETUP" is set to "RIGID," proceed to the next step.
several times until the screen shown on
.
several times until the screen shown on
.
to select "5 mm (3/16 inch)."
to enable the setting.
to select
.
5
125