NETGEAR ProSafe WC7520 Reference Manual page 77

QoS prioritization and coordination of wireless medium access is on and QoS settings on the
access point control downstream traffic, flowing from the access point to client station (AP
EDCA parameters) and the upstream traffic flowing from the station to the access point
(station EDCA parameters).
To configure the QoS settings:
Select Configuration > Wireless > Advanced > QoS. The Advanced QoS Settings
1.
screen displays:
Figure 45.
This screen lets you modify the QoS control of parameter per managed access point
group for upstream traffic flowing from the station to managed access point and the
downstream traffic flowing from managed access point to the client station. These
settings are applied only to managed access points supporting these settings.
Disabling WMM deactivates QoS control of station EDCA parameters on upstream traffic
flowing from the station to the access point. With WMM disabled, you can still set some
parameters on the downstream traffic flowing from the access point to the client station
(AP EDCA parameters).
Configure the settings as explained in
2.
Click Apply to save your settings.
3.
76 | Chapter 7: Configuring Wireless Settings
ProSafe 20-AP Wireless Controller WC7520 Reference Manual
Table 20, QoS Settings
on page 77.