NETGEAR ProSafe WC7520 Reference Manual page 32

ProSafe 20-AP Wireless Controller WC7520 Reference Manual
Figure 12.
The APs and wireless controllers are connected in the same subnet and same VLAN and use
the same IP address range that is assigned for that subnet. The core switch is located in
between the wireless controllers and the PoE switches, to which the APs are connected. The
core switch provides Internet access.
Prerequisites
This network configuration has the following prerequisites:
VLAN 1 is configured on the wireless controllers, core switch, and PoE switches. This
•
VLAN is untagged.
VLANs 10, 20, and 30 are configured on the wireless controllers, core switch, and the
•
PoE switch in Building 1. These VLANs are tagged.
VLANs 1, 10, 20, 30, and 40 are configured on the wireless controllers, core switch, and
•
PoE switches. Except for VLAN 1, these VLANs are tagged.
Provisioning the Wireless Controller
To provision the wireless controllers in this network, perform the following tasks:
Configure the basic system configuration:
1.
Configure the country code of operation (see
•
page 52).
Configuring General Settings
Chapter 2: System Planning and Deployment Scenarios
on
| 31