Single Controller Configuration With Access Point Groups - NETGEAR ProSafe WC7520 Reference Manual

ProSafe 20-AP Wireless Controller WC7520 Reference Manual
Step Configuration
If you have not yet done so, configure the system settings of
2.
the wireless controller:
1. Configure the country code of operation.
2. Configure the IP address of wireless controller.
3. Verify that VLAN 1 is set as the management VLAN and is
marked as untagged, which is the default setting.
Configure up to 8 profiles, and for each profile, do at least the
3.
following:
1. Configure an SSID for wireless access.
2. Configure the network authentication and data encryption.
3. Assign the VLAN.
If required, configure the authentication server.
Run the Discovery Wizard and add the APs to the managed AP
4.
list.

Single Controller Configuration With Access Point Groups

A more complex configuration consists of a single wireless controller that controls a collection
of APs that are organized in AP profile groups and might use several profiles in each AP
profile group.;
To set up a single wireless controller system with AP profile groups, follow these steps:
Step Configuration
Optional: Create an RF plan.
1.
If you have not yet done so, configure the system settings of
2.
the wireless controller:
1. Configure the country code of operation.
2. Configure the IP address of wireless controller.
3. Verify that VLAN 1 is set as the management VLAN and is
marked as untagged, which is the default setting.
Chapter 2: System Planning and Deployment Scenarios
Chapter/Section Reference
See
Chapter 5, Configuring Network
Settings
See
Configuring General Settings
page 52
See
Configuring IP and VLAN Settings
on page 53
See
Chapter 8, Configuring Security
and Wireless Security Profiles
See
Configuring Basic Security Profiles
on page 91
See
Managing Authentication Servers
and Authentication Server Groups
page 93
See
Access Point Discovery and
on page 42.
Management
Chapter/Section Reference
See on page 33
RF Planning
See
Chapter 5, Configuring Network
Settings
See
Configuring General Settings
page 52
See
Configuring IP and VLAN Settings
on page 53
on
on
on
| 23