Rear Panel Features; Bottom Panel With Product Label - NETGEAR ProSafe WC7520 Reference Manual

Table 1.
LED Status
Off
Right LAN
port LED
On (amber)
(one for
each port)
On (green)

Rear Panel Features

The following figure shows the rear panel components of the wireless controller.
Figure 2.
From left to right, the wireless controller's rear panel components are:
Console port. RS232 port for connecting to an optional console terminal. The port has a
•
DB9 male connector. The default baud rate is 9600 K. The configuration is 8 bits, no
parity, and 1 stop bit.
Factory default reset button. Using a sharp object, press and hold this button for about
•
10 seconds until the front panel Test light flashes and the wireless controller returns to
factory default settings.
If you reset the wireless controller, all configuration settings are lost
Note:
and the default passwords are restored.
Kensington lock. Attach an optional Kensington lock to prevent unauthorized removal of
•
the wireless controller.
AC power socket. Attach the power cord to this socket. (There is no separate on/off power
•
switch.)

Bottom Panel With Product Label

The product label on the bottom of the wireless controller's enclosure displays the default IP
address, default user name, and default password, as well as regulatory compliance, input
power and other information.
Figure 3.
10 | Chapter 1: Introduction and Overview
ProSafe 20-AP Wireless Controller WC7520 Reference Manual
Description
The port is operating at 10 Mbps.
The port is operating at 100 Mbps.
The port is operating at 1000 Mbps.