NETGEAR ProSafe WC7520 Reference Manual page 57

The wireless controller can function as a DHCP server. Multiple DHCP server pools can be
added for different VLANs. This screen lets you enable and configure the DHCP server. You
can also add DHCP servers.
To configure DHCP settings:
Select Configuration > System > DHCP. The DHCP Settings screen displays:
1.
Figure 29. DHCP Settings
Configure the settings as explained in
2.
Click Apply to save your settings.
3.
Table 11. DHCP Settings
Field
VLAN
IP Network
Subnet Mask
Default Gateway
Start IP
End IP
Primary DNS Server
Secondary DNS Server
WINS Server
To add a DHCP Server to the list:
Select Configuration > System > DHCP to go to the DHCP screen.
1.
56 | Chapter 5: Configuring Network Settings
ProSafe 20-AP Wireless Controller WC7520 Reference Manual
Table 11, DHCP Settings
Description
The DHCP server VLAN ID. The range is between 1 and 4094. The DHCP server will
service this VLAN.
The IP address for the wireless controller in the specified VLAN; when the Use VLAN
Interface check box is not selected, the wireless controller management IP/VLAN is
used.
The subnet mask that will be assigned to the wireless clients by the DHCP server.
The IP address of the default network gateway for all traffic beyond the local network.
The starting IP address of the range that can be assigned by the DHCP server.
The ending IP address of the range that can be assigned by the DHCP server.
Enter the IP address of the primary DNS server for the network.
Enter the IP address of the secondary DNS server for the network.
Enter the IP address of the WINS Server for the network.
on page 56.