ProSafe 20-AP Wireless Controller WC7520 Reference Manual
referred to as channel width) to provide the best channel for the AP. For information about
how to configure auto channel allocation, including the option to skip auto channel
allocation if there is a heavy traffic load or voice activity, see
page 70.
Auto transmission power. Automatically determines the optimum transmit power of an
•
AP based on the coverage requirement. The AP scans its neighborhood to determine the
RF environment to minimize neighboring AP interference, leakage across floors, and
coverage holes. For information about how to configure auto transmission power,
including coverage hole detection, see
When configuring self healing, NETGEAR recommends the following:
Configure self healing wait time to a value greater than access point reboot time, usually
•
a minute. This allows for fluctuations in the power of nearby access points when access
points are rebooted.
The number of neighbors to participate in healing should not be very large (3-4 usually
•
suffices in most deployments). This avoids too many access points increasing power for a
single failed access point.
Basic RF Management
To configure basic RF management:
Select Configuration > Wireless > Basic > RF Management. The Basic RF
1.
Management screen displays:
Figure 43.
Configure the settings as explained in
2.
Specifying RF Management
Table 19, RF
Management.
Chapter 7: Configuring Wireless Settings
Configuring Channels
on page 72.
on
| 73