Mounting The Branch Gateway On A Wall - Avaya G450 Quick Start For Hardware Installation

Mount the devices
7. Either tighten the two bottom-most screws inserted in step
8. Verify that ventilation vents are not obstructed.
Result
At this point, you have mounted the Branch Gateway chassis in the rack and are ready to insert
media modules as required in the planning documentation.

Mounting the Branch Gateway on a wall

To mount the Branch Gateway on a wall, use the two mounting brackets without cable guides.
You can also add a mounting bracket with cable guides if desired, as explained in
with cable guides
Warning:
Only service-trained personnel are to wall-mount the Branch Gateway.
Caution:
One person may wall mount a G450 if the PSUs are removed. See . A minimum of two
installers is required to wall-mount a Branch Gateway with the PSUs installed.
Caution:
If you are installing the Branch Gateway in the United States of America:
• The AC power supply cord must not be attached to the building wall, for example with
wire staples, clamps, and so on.
• You must install the Branch Gateway near the AC receptacle (socket outlet) that
services the Branch Gateway.
• You must install the AC power supply cord in a way that minimizes the risk of physical
damage to the cord. The cord must not be hanging on the floor, or routed in any way
that can subject it to physical abuse.
Attaching brackets to the Branch Gateway for wall mounting
Fastening the Branch Gateway to the wall
Attaching brackets to the Branch Gateway for wall mounting
Attach a bracket to each side of the Branch Gateway, as shown in
24 Quick Start for Hardware Installation: Avaya G450 Branch Gateway
remove them completely.
on page 21.
Related topics:
on page 24
on page 25
1 on page 0 , or
Brackets
the figure.
February 2011