Error Messages - Konica Minolta 7115F Instruction Manual

Error Messages

Message
SET ORIGINAL TO ADF
REMOVE PAPER
TEXT
ä[A]ü#XXX:EMPTY
NO SUITABLE PAPER
(Flashing alternately)
LOAD PAPER (#XXX)
APS SIZE ERROR
AMS SIZE ERROR
PAPER SIZE ERROR
(Flashing alternately)
RESET PAPER (#XXX)
Konica 7115F/7118F
Cause
A document was not loaded
into the Automatic Document
Feeder before beginning a
copy function (such as,
"2 in 1" copying or "Mixed
Orig." copying) that uses the
Automatic Document Feeder.
Otherwise, the Automatic
Document Feeder is lifted up.
When interrupting a copy job
to perform a different copy
operation other than the
"Dual Page" function, the
document for the interrupted
copy job was left in the
Automatic Document Feeder.
×
1.0 1 (While specifying copy
settings)
The selected paper tray has
run out of paper.
"#" indicates the paper tray,
and "XXX" indicates the
paper size.
• While copying, the size of
the paper in the selected
paper tray has changed.
• While copying documents
with mixed sizes using the
"APS" function, paper of a
suitable size could not be
found.
"#" indicates the paper
tray, and "XXX" indicates
the paper size.
While copying using the
"APS" function, paper of a
suitable size could not be
found.
While copying using the
"AMS" function, the
combination of the document
and paper sizes caused the
zoom ratio to exceed the
range between
×
2.0.
The paper loaded in the
paper tray caused a size
error.
"#" indicates the paper tray,
and "XXX" indicates the
paper size.
Remedy
Load a document into the
Automatic Document Feeder.
Securely close the Automatic
Document Feeder.
Remove the document from
the Automatic Document
Feeder.
Either load paper of the
specified size into the
specified paper tray, or press
the [PAPER SIZE] key and
select a different paper size.
Either load paper of the
specified size, or press the
[PAPER SIZE] key and select
a different paper size.
Either load paper of a
suitable size, or press the
[PAPER SIZE] key and select
a different paper size.
Either load paper of a
suitable size, or use the [
and [ ] keys to specify the
zoom ratio.
×
0.5 and
Pull open the paper tray with
the size error, and then close
it again.
Check if a custom paper size
has been entered, and
correct the paper size using
the appropriate Initial Set
mode function.
12
]
12-19