Error Messages Displayed - Konica Minolta bizhub C360 User Manual

12.3

Error messages displayed

12.3 Error messages displayed
If the machine encounters a problem, an error dialog will appear and display one of the following error mes-
sages. Take corrective actions by referring to the table below.
If a communication error persists, please contact your service representative.
12.3.1 G3 Fax
Error Message
[Failed to complete the
job due to an error while
dialing.]
[Unable to check send-
er.]
[Not enough memory to
continue scanning.]
[Transmission failed.
Please check line con-
nection.]
[Cannot connect to the
network.]
[The address for the
communication method
cannot be selected since
the number of addresses
has exceeded the maxi-
mum allowed for broad-
casting.]
[Document could not be
saved in the User Box
due to insufficient HDD
capacity. Check log.]
[The number of regis-
tered user boxes has
reached the maximum
allowed.]
[This user box has
reached its maximum
number of pages al-
lowed.]
[The maximum number
of jobs has been queued.
Wait until a queued job is
completed.]
bizhub C360/C280/C220
Downloaded From ManualsPrinter.com Manuals
Corrective Actions
Redial was attempted the number of times specified, however, transmission
failed because the recipient was busy or due to other reasons.
Check the recipient's state to resend the fax.
The machine failed to verify the recipient with Check Dest. & Send set to
[Yes].
Check that the receiver's fax number is registered correctly.
During scanning of original, the memory became full.
Press Start to send scanned originals. Press Stop to stop faxing.
The telephone cord may have become unplugged.
Check the telephone cord for connection and, if unplugged, plug it securely.
Make sure that the network cable is correctly connected. In addition, make
sure that [Network Settings] in Administrator Settings is correctly configured.
The number of destinations specified exceeds the number possible for a
broadcast transmission. Reduce the number of broadcast destinations, or
send the transmission in multiple batches.
Check log The hard disk is full.
The number of User Boxes that can be registered has reached the maximum
number possible. Delete unnecessary User Boxes, and then try registering
new boxes again.
The number of documents that can be saved in a User Box has reached the
maximum number possible. Delete unnecessary documents, and then try
saving the document again.
The number of jobs that can be programmed has reached the maximum
number possible. Wait until a job has been completed, or delete a current job.
12
12-6