Axis 5570e User Manual page 99

AXIS 5570e/AXIS 5670e User's ManualSection 5: Setting Up - IBM Mainframe (zSeries)
Starting and stopping
the PSF/MVS printer
Starting the printer
Although it is not recommended, it is possible to drive the printer
with just one FSA, if one of the following conditions are met:
• All the resources in the resource libraries are resolution-indepen-
dent, and all the jobs that use inline resources or user libraries
contain resources that are resolution-independent.
• All jobs that request a resolution that is different from the reso-
lution-dependent resources in the PSF system and security librar-
ies contain the resources at the requested resolution, either as
inline resources or in the user's library.
Even if a PSF user requests 120-pel resolution for an AFP print job
being sent to the printer, PSF requires 240-pel resources from the
library. Do not store 120-pel resources in the library.
When operating the AXIS 5570e/AXIS 5670e when emulating a
TCP/IP attached IPDS printer, you should use JES operator commands,
just as if the printer were channel-attached or SNA-attached.
To start a TCP/IP-attached printer, do the following:
1. Start TCP/IP.
2. Power on the printer(s).
3. Power on the AXIS 5570e/AXIS 5670e.
4. Start the printer FSA as indicated below.
Before starting a PSF FSS, you must have a cataloged startup
procedure in SYS1.PROCLIB or any other system procedure library.
This procedure specifies PSF initialization parameters and libraries
that contain system and installation resources. The name of this
procedure can be specified in the FSSDEF statement of the JES
initialization deck. If the name is omitted, JES3 supplies a default
name, that is chosen for the defined printer.
99