Axis 5570e User Manual page 83

AXIS 5570e/AXIS 5670e User's ManualSection 5: Setting Up - IBM Mainframe (zSeries)
Specifying the TCP/IP
address space name
Defining the
MVS control unit
To specify a TCP/IP address space name you should enter the
following EXEC statement in the appropriate PSF writer procedure:
//STEP01 EXEC
PGM=APSPPIEP,REGION=4096K,PARM=(,,,,tcpip_name)
where
tcpip_name
parameter is not coded, PSF uses the default name
description of the
covering the print service facility.
If you have not already done so, you must define the communications
control unit, e.g. the 3172 control unit or the 3745 control unit, to
MVS. The tool to use is dependent on your MVS version:
• When using a version earlier than MVS 4.1.0, you should use an
MVS Configuration Program (MVSCP).
• When using a version of MVS 4.1.0 or higher, you can use a
HardWare Configuration Definition (HCD) or an MVSCP.
For more information about using these methods, please refer to one
of the following publications:
• MVS/ESA Planning: Dynamic I/O Configuration
• OS/390 HCD Planning
• HCD User's Guide
is the name of the TCP/IP address space. If this
parameter refer to IBM's user documentation
PARM
. For a full
TCPIP
83