Setting Up 3Dm Preferences - 3Ware 9650SE-2LPML User Manual

Chapter 6. 3DM 2 (3ware Disk Manager) Introduction

Setting Up 3DM Preferences

76
Table 8: List of 3DM Pages
3DM Page
Maintenance page
Alarms page
Battery Backup page
Enclosure Summary
page
Enclosure Details
page
3DM 2 Settings page
The 3DM 2 Settings page lets you define preference settings that affect the
overall operation of 3DM. Most of these settings are specified initially during
installation of 3DM.
On the 3DM 2 Settings page you can perform the following tasks:
• Setting and Changing 3DM Passwords
• Managing E-mail Event Notification
• Enabling and Disabling Remote Access
• Setting the Incoming Port #
• Setting the Frequency of Page Refreshes
Description
Lets you configure new units and make changes to
existing units.
To view this page, choose Management > Maintenance
from the menu bar.
Shows a list of alarms, including the specific alarm
message, and the exact date and time it occurred.
To view this page, choose Monitor > Alarms on the menu
bar.
Shows the status of a Battery Backup Unit (BBU), if one is
installed, and allows you to test the battery.
To view this page, choose Monitor > Battery Backup on
the menu bar.
Lists the enclosures attached to your 3ware controller.
To view this page, choose
Support
on the menu bar.
Shows details about a particular enclosure, including
status information. You can also use this page to blink the
LED for a particular drive.
To view this page, click the ID number of the Enclosure on
the Enclosure Summary page.
Lets you set preferences, including email notification for
alarms, passwords, page refresh frequency, whether
remote access is permitted, and the incoming port which
3DM will use for listening.
To view this page, click 3DM 2 Settings on the menu bar.
3ware Serial ATA RAID Controller User Guide
Monitor > Enclosure