3Ware 9650SE-2LPML User Manual page 146

Chapter 9. Maintaining Units
136
The unit is not fully fault tolerant until the rebuilding is complete. For
more information, see "To verify a unit through 3BM" on page 149.
• Rebuild-Paused. The unit is set to rebuild, however scheduling is
enabled, and the present time is not during a scheduled timeslot.
Rebuilding will start at the next scheduled time slot. Rebuilds are also
paused for up to ten minutes after a reboot, even during a scheduled
timeslot.
• The unit is in the process of writing to all of the disks in the
Initializing.
unit in order to make the array fault tolerant. For more information, see
"About Initialization" on page 143.
• Initializing-Paused.
enabled and the present time is not during a scheduled timeslot.
Initializing will start at the next scheduled time slot. Initialization is also
paused for up to ten minutes after a reboot, even during a scheduled
timeslot.
• The unit is in the process of ensuring that the parity data of a
Verifying.
redundant unit is valid. For more information, see "About Verification"
on page 146.
• Verify-Paused. The unit is set to verify, however, scheduling is enabled,
and the present time is not during a scheduled timeslot. Verification will
start at the next scheduled time slot.
• The unit is in the process of being reconfigured while it is
Migrating.
online. Migration can be used to change the RAID level, to expand the
capacity by adding additional drives, or to change the stripe size. For
more information, see "Changing An Existing Configuration by
Migrating" on page 115.
• Migrate-Paused. The unit is in the process of migrating, however
scheduling is enabled, and the present time is not during a scheduled
timeslot. Migrating will start at the next scheduled time slot. Migration is
also paused for up to ten minutes after a reboot, even during a scheduled
timeslot.
• One or more drives in the redundant unit is no longer being
Degraded.
used by the controller. For more information, see "About Degraded
Units" on page 137.
• This is a condition where one or more drives are missing
Inoperable.
from a unit, causing the unit to no longer be available to the operating
system. Data on an inoperable unit cannot be accessed. For more
information, see "About Inoperable Units" on page 138.
The unit is set to initialize, however scheduling is
3ware Serial ATA RAID Controller User Guide