3Ware 9650SE-2LPML User Manual page 210

Chapter 11. 3DM 2 Reference
200
Follow Schedule/Ignore Schedule.
for the Rebuild/Migrate and Verify tasks by selecting either
or . When schedules are set to be ignored, these tasks can be
Ignore Schedule
performed at any time, and are not restricted to the scheduled times.
Note:
Scheduling of these tasks is only available on the 9000-series controllers.
For details about the different background tasks, see "Background Tasks" on
page 142.
Task Schedules
Initially, 7 schedule slots are defined, for 24 hours each. Even if
Schedule is enabled, this schedule is equivalent to
tasks can run at any time, round the clock.
A maximum of 7 slots can be created, so to set a different schedule, start by
deleting one or more of the existing scheduled slots, and then add new slots.
For step-by-step instructions for adding and removing schedules, and setting
schedules to be followed or ignored, see "Scheduling Background Tasks" on
page 156.
Self-test Schedules
Unlike scheduling of rebuilds and verifies, scheduling of self-tests is always
followed. To disable self-tests you either remove all schedule times, or
uncheck the tests listed in the Tasks column.
Note:
Only the checked tasks will be run during the scheduled times. If none of the
tasks are checked, self-tests will never run, even if you have scheduled time slots
set.
Two self-tests can be scheduled:
Upgrade UDMA mode.
drives is occurring, to see if the UDMA mode can be increased. (If you are
already running at the fastest UDMA mode, then this self-test has no effect.)
You can enable or disable the schedule
This test checks the speed at which data transfer to
3ware Serial ATA RAID Controller User Guide
Follow Schedule
Follow
Ignore Schedule , because