Ordering Units In 3Bm - 3Ware 9650SE-2LPML User Manual

Chapter 8. Configuring Units

Ordering Units in 3BM

100
12 When you are finished making configuration changes, press
the changes and exit 3BM.
A warning message tells you that all existing data on the drives will be
deleted, and asks you to confirm that you want to proceed.
Figure 50. Confirmation Message when Saving and Exiting
If you made changes to units on more than one controller, the details
about changes about to be made may extend beyond one screen. In this
case, you use the
PgUp
view.
13 Type to continue, delete any existing data on the drives, and create the
Y
unit.
14 Partition and format the units, as described under "Partitioning,
Formatting, and Mounting Units" on page 101.
Note:
For RAID 5 and RAID 6units with 5 or more disks, and RAID
50 units with a subunit of 5 or more disks, initialization of the unit
begins immediately. You can postpone initialization if you want to
begin using the units right away, however initialization from the BIOS
is faster than it is under the operating system, so it will be a longer
period of time until the unit has optimal performance. For more
information, see "About Initialization" on page 143.
If you configure multiple units in 3BM and you want to install the OS on one
of them so that you can boot from that unit, that unit must be the first unit.
You can change the order of the units in 3BM.
To change the order of units in 3BM
1 At the main 3BM screen, in the list of exportable units, highlight the unit
you want to move.
and keys to bring more information into
PgDn
3ware Serial ATA RAID Controller User Guide
to save
F8