Driver Installation Under Windows; Materials Required - 3Ware 9650SE-2LPML User Manual

Driver Installation Under Windows

Materials Required

www.3ware.com
Note:
Before installing the 3ware driver, you must have already physically installed
your 3ware RAID controller in the system.
Consult the installation guide that came with your controller for how to do this. You
can download that guide from: http://www.3ware.com/support/userdocs.asp.
The 3ware RAID controller can be used with Microsoft Windows 2000 (SP3
or newer), Windows XP (SP1 or newer), and Windows Server 2003. Windows
2003 64-bit for AMD Opteron or Intel EM64T is also supported. It is
recommended that you upgrade to the latest service pack available.
A drive or unit managed by the 3ware RAID controller may be configured to
be your system's boot device. Or, you can use units managed by the 3ware
controller for secondary storage and boot from another device, such as a disk
attached to the motherboard, or other bootable media.
This section contains instructions for how to:
• Create a driver diskette for the 3ware RAID controller
• Install the 3ware driver and Windows on a new drive or unit.
• Install the 3ware driver when Windows is already installed on a different
device.
Note:
You must have administrator privileges for your system to install the
Windows operating system and the 3ware driver.
• 3ware software CD-ROM
• Microsoft Windows 2000, XP, or Server 2003 installation CD-ROM. (Not
required if Windows is already installed on another drive.).
• Floppy diskette, to create a driver diskette.
If you are installing Windows onto the RAID unit you are creating, you
must create a 3ware driver diskette. If Windows is already installed on
another device, you may install the 3ware driver from either the 3ware
software CD-ROM or from a diskette.
Driver Installation Under Windows
31