Removing And Installing The Front Door On Cisco 12404 Enhanced Series Router - Cisco 12404 Installation And Configuration Manual

Removing and Installing the Front Door on Cisco 12404 Enhanced Series Router

Step 7
Step 8
Caution
Step 9
Removing and Installing the Front Door on
Cisco 12404 Enhanced Series Router
Cisco 12404 Internet Router Installation and Configuration Guide
5-6
Visually check that all RP and line card LEDs are all off.
Visually check that the CSF LEDs are all off.
In a noisy environment, place your hand in front of the fan compartment on each
part with a fan, to ensure the fans are all off.
Remove all power lines positive (+), negative (-) and ground wires connected to
the DC PDU block.
The Cisco 12404 enhanced series router has a new one-piece front door. The
router ships with the door hinge mounted on the left side of the chassis so that it
opens from right-to-left. This section describes how to change the front door to
open from left-to-right by installing the hinge on the opposite side.
Use the following procedure to change the location of the hinge.
Chapter 5 Maintaining the Cisco 12404 Internet Router
OL-11636-01