Bpdu-Tunnel Tunnel-Dmac - HP A5830 Series Command Reference Manual

hgmp: Specifies the HGMP.
lacp: Specifies the LACP.
lldp: Specifies the LLDP.
pagp: Specifies the PAGP.
pvst: Specifies PVST.
stp: Specifies the STP.
udld: Specifies UDLD.
vtp: Specifies the VTP.
Examples
# Disable STP on GigabitEthernet 1/0/1, and then enable BPDU tunneling for STP on the port.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo stp enable
[Sysname-GigabitEthernet1/0/1] bpdu-tunnel dot1q stp
# Disable STP for port group 1, and then enable BPDU tunneling for STP in the port group.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/1 to gigabitethernet 1/0/6
[Sysname-port-group-manual-1] undo stp enable
[Sysname-port-group-manual-1] bpdu-tunnel dot1q stp
# Disable STP on Layer 2 aggregate interface Bridge-Aggregation 1, and then enable BPDU tunneling for
STP on the Layer 2 aggregate interface.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] undo stp enable
[Sysname-Bridge-Aggregation1] bpdu-tunnel dot1q stp

bpdu-tunnel tunnel-dmac

Description
Use the bpdu-tunnel tunnel-dmac command to configure the destination multicast MAC address for
BPDUs.
Use the undo bpdu-tunnel tunnel-dmac command to restore the default value.
By default, the destination multicast MAC address for BPDUs is 0x010F-E200-0003.
Syntax
bpdu-tunnel tunnel-dmac mac-address
undo bpdu-tunnel tunnel-dmac
View
System view
141