QMS Magicolor WX User Manual page 204

4 Remove any jammed media you see.
5 Check to be sure no other pieces of media are lodged farther
back in the slot. Then, if you removed the manual-feed plat-
form, replace it.
Push it back into the printer until it is secure.
6 Make sure the media in the cassette is in good condition, lies
flat, and does not exceed the upper-limit mark on the cas-
sette.
7 Slide the cassette back into the printer until it's secure.
8 Open and close the top cover to clear the jam message in the
control panel window.
When the control panel message window displays IDLE, the printer is
ready to print.