Back Panel Open; Belt Cartridge Misinstalled; Replacing The Waste Toner Pack - QMS Magicolor WX User Manual

» Note: Some printer status messages do not automatically clear after
corrective action has been made to the printer. To clear such a
message, use the procedure given in "Clearing Status Messages" on
page 7-16.
When the printer needs operator assistance, the message window
displays one of the following messages:
This message . . .
BACK PANEL
MISINSTALLED
BELT CARTRIDGE
MISINSTALLED
CANCELING JOBS
CHECK WASTE
TONER
x DEVELOPER
MISINSTALLED
means . . .
The back cover over the transfer unit is not
fully closed. Close the back cover.
The OPC belt cartridge is either not installed or
incorrectly installed. Either install a cartridge if
one is not present or reinstall the current one
correctly. (See chapter 5, "Maintenance," for
information on replacing the OPC belt
cartridge.)
The Cancel key has been pressed, and all
pages currently received by the printer are
being cancelled.
The waste toner pack is full and needs to be
replaced or is not installed properly. Make sure
the pack is not full, and that it sits loosely in its
compartment, not wedged under the top of the
compartment. See "Replacing the Waste
Toner Pack" in chapter 5, "Maintenance," for
details.
A developer cartridge is not installed or
installed incorrectly. The x is replaced by the
color of the developer unit that needs
attention. Either install a developer cartridge if
one is not present or reinstall the current one
correctly. (See chapter 5, "Maintenance," for
information on replacing the developer
cartridge.)