QMS Magicolor WX User Manual page 194

Note: Changing the print density affects the resident color
»
management system and should be done only as a last step to
improve print quality. The normal setting is the center position.
Normally, your laser printer produces a rich black or color image.
However, you may occasionally notice a color is printing a bit light or
dark. In this case, you may want to increase the print density (or con-
trast) setting for that color. To change density settings, use the follow-
ing procedure:
1 Remove the top cover by lifting it up and out. Then, set the
cover aside for now.
2 Locate the adjustment dials inside the printer to the front
left.
K
C
M
Y
3 Turn the density adjustment dial to the left (counterclock-
wise) to lighten the print or to the right (clockwise) to darken
the print.