QMS Magicolor WX User Manual page 199

This message . . .
REPLACE FUSER
REPLACE OIL AND
PAD
REPLACE x
DEVELOPER
SERVICE MODE
SIDE PANEL
MISINSTALLED
SLEEPING
TOP PANEL
MISINSTALLED
x TONER EMPTY
WARMING UP
means . . .
It's time to replace the fuser to ensure print
quality and reduce wear on your printer.
Caution: We strongly recommend that you
have the fuser replaced as soon as
possible after a message appears. If you
continue to use the printer without the
proper maintenance or part replacement,
print quality can deteriorate, and the wear
on the printer can shorten the printer's life.
The oil bottle for the fuser unit is empty and the
cleaning pad needs to be replaced. The printer
will not run any more copies until they are
replaced. (See chapter 5, "Maintenance," for
information on replacing the oil bottle and
cleaning pad.)
A developer cartridge needs to be replaced.
The x is replaced by the color of the developer
cartridge that needs attention. (See chapter 5,
"Maintenance," for details.)
The printer is being serviced.
The waste toner cover is not fully closed.
Close the cover.
Energy Save mode is currently in effect.
The top cover of the printer is either off or
partially open. Make sure it is seated properly
and fully closed.
A toner cartridge is empty. The x is replaced
by the color of the toner cartridge that needs to
be replaced. (See chapter 5, "Maintenance,"
for information on replacing a toner cartridge.)
The printer is warming up; the fuser is at a low
temperature. Wait until the printer has warmed
up before you print.