Table of Contents
Advertisement
This message . . .
FUSER OIL OUT
IDLE
INNER JAM
WX BOARD TEST
MEMORY INSTALLED
x MEG VER x.x
MISFEED JAM
NEED MORE MEMORY
PAPER MISMATCH
OUTER JAM
PAPER LOSS
PAPER OUT
UPPER TRAY
PAPER OUT
LOWER TRAY
means . . .
The oil bottle for the fuser unit is running low
and the cleaning pad is wearing out. If you
have a new oil-bottle/pad kit on hand, you may
want to replace them now. (See chapter 5,
"Maintenance," for information on replacing
them.) If not, order a replacement kit now. A
limited number of copies (approximately 100)
will still run. However, when the oil runs out,
the printer stops and the ADD FUSER OIL
AND REPLACE PAD status message appears.
No jobs are in progress.
Media has jammed leaving the OPC belt
cartridge area. Remove the jam (see "Clearing
Inner Jams" on page 7-21).
The printer is going through its initial testing
during startup.
This indicates the amount of memory installed
in the printer and the system software version.
It displays immediately after WX BOARD TEST
during printer startup.
Media has jammed leaving the media
cassette. Remove the jam (see "Clearing
Misfeed Jams" on page 7-18).
More memory is needed to print the job, and
the media in the default media cassette is
different from that chosen in the printer driver.
Media has jammed leaving the paper exit unit.
Remove the jam (see "Clearing Outer Jams"
on page 7-27).
Printing has been interrupted because the
default cassette has been removed.
The indicated media cassette is empty; reload
the cassette. (See chapter 2, "Printing," for
information on refilling cassettes.)
Advertisement
Chapters
Table of Contents
